Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Liner & Rebuild in Sherman Oaks: What to Know First
We provide independent Olympia Chimney chimney liner and rebuild service in Sherman Oaks, with most liner replacements completed in one day and full rebuilds typically scheduled within a week. Every job starts with a written price before any work begins - no exceptions, no surprises. If you own an Olympia Chimney system and you’re seeing rust flakes in the firebox, hearing a hollow ring when you tap the flue, or you’ve been told you need a liner but weren’t shown why, this page is for you. Call (424) 414-6048 for a free estimate with camera inspection included.
How Olympia Chimney Products Fail - and How We Fix Them
- Olympia Chimney Flex-All stainless liners develop circumferential cracking at the flex points after 8-12 years in the San Fernando Valley’s thermal-cycling climate. The daily heat-up and cool-down hardens the corrugated sections faster than in coastal zones. We cut back to sound metal and splice in a new DuraFlex or matching Olympia section, then document the joint with photos under Haven Standard Clause 4.
- Olympia Chimney smooth-wall rigid liners in the 6″ and 8″ diameter common to Sherman Oaks ranch remodels separate at the telescoping joints. The slip joint loosens, creosote leaks into the chimney cavity, and you smell it before you see it. We pull the damaged section, reseat with proper expansion allowance, and pressure-test the joint before we leave.
- Olympia Chimney pumice liners (the white, porous units found in 1960s-70s Sherman Oaks construction) spall from the inside when gas logs are retrofitted without proper sizing. The lower flue temperature lets moisture condense, freeze, and flake the pumice. We remove the degraded pumice and drop in a correctly sized stainless liner, typically 5.5″ for a 36″ opening, with a new connector assembly.
- Olympia Chimney top-sealing dampers integrated with their chase covers seize in the open position after the cable sheath fills with Valley dust and roof grit. The damper doesn’t close, the flue stays open, and your conditioned air exits year-round. We disassemble, clean the cable run, and replace the damper assembly if the casting is cracked - which it often is on units installed before 2015.
- Olympia Chimney multi-flue chimney pots and crown assemblies crack at the bed joint where the pot meets the crown, letting water track down between flues. In Sherman Oaks, this accelerates after Santa Ana wind cycles because the rapid drying shrinks the mortar. We grind out the joint, repoint with hydraulic lime, and install a Gelco or Famco cap with proper clearance and drip edge.
Our Olympia Chimney Chimney Liner & Rebuild Process
- 1
Call and schedule. A live person answers, checks availability, and books your NFPA 211 Level 2 inspection. You’ll get a text when your tech is en route.
- 2
Camera inspection and findings. We run a chimney camera the full flue length, record the footage, and show you the liner condition, joint integrity, and any spalling or gaps. Corrine Halstead reads the footage with you - findings first, opinion second.
- 3
Written price and scope. Before any tool touches your chimney, you receive a written price, written scope, and written warranty. Haven Standard Clause 1: have it in writing. No verbal quotes, no “we’ll see once we’re in there.”
- 4
Parts decision. We stock DuraFlex, HeatShield, Gelco, and Olympia-compatible components through our Haven buying network. If your Olympia part is available at honest lead time, we’ll use it. If an aftermarket equivalent meets or exceeds the spec and saves you money, we’ll show you both options.
- 5
Repair and test. Liner replacement or rebuild proceeds per scope. We perform a smoke test or draft reading to verify performance, then photograph the completed work.
- 6
Documentation and follow-up. You leave with photos, camera footage, written warranty, and our 365-Day Done Right Promise. The record stays in our archive, continuous since 2009.
BeforeAfterWhat Olympia Chimney Chimney Liner & Rebuild Costs in Sherman Oaks
| Service | Typical Range | What Moves the Price |
|---|---|---|
| Olympia Chimney stainless liner replacement (single flue, standard height) | $2,800 - $4,200 | Flue length, diameter, number of offsets, access difficulty |
| Olympia Chimney flexible liner with insulation wrap | $3,400 - $5,100 | Insulation thickness, top plate style, whether the damper must be modified |
| Partial chimney rebuild (crown, upper courses, cap) | $3,200 - $6,500 | Scaffolding needs, brick match, extent of water damage below the crown |
| Full chimney rebuild above the roofline | $8,500 - $14,000 | Height, brick or stucco finish, liner replacement bundled, permit requirements |
| Olympia Chimney liner repair (sectional splice, joint repair) | $1,200 - $2,400 | Accessibility of the damaged section, whether the surrounding masonry needs opening |
These are real Sherman Oaks prices for real Olympia Chimney work - not teaser rates. We adjust only for what we find, and we show you the camera evidence before we adjust anything. Call (424) 414-6048 for your exact written estimate. Estimates are free.
Why Sherman Oaks Homeowners Call Emberly Chimney Cleaners Sherman Oaks for Olympia Chimney Work
We’ve inspected over 38,000 chimneys since 2009, and a significant share of the older stock in Sherman Oaks - the wood-framed homes along Ventura Boulevard, the hillside stucco builds with exterior chimneys, the ranch remodels with converted fireplaces - runs Olympia Chimney components. Corrine Halstead and our crew know the product line’s weak points from repeated exposure, not from a distributor brochure.
Our 365-Day Done Right Promise means if the liner doesn’t draft right, if a joint leaks, if anything fails from our workmanship, we make it right. No charge. No argument. Haven Standard Clause 4 requires the photo record that proves what was there before and what we left behind. The camera doesn’t lie, and neither does the written quote.
We also carry DuraFlex, HeatShield, and Gelco materials, so if your Olympia part is discontinued or back-ordered, we don’t leave you waiting. Independent buying power keeps your price honest.
FAQs
No - but understand that Olympia Chimney’s product warranty covers manufacturing defects, not installation or wear. As an independent Olympia Chimney service provider, we perform warranty-safe work using correct materials and methods. If your liner failure is a true defect and the unit is within warranty period, we document it so you can pursue a claim with Olympia directly. We don’t represent Olympia Chimney, and we don’t handle their warranty reimbursement. Call (424) 414-6048 and we’ll sort out what’s a defect versus what’s wear.
We source both. Through our Haven buying network, we procure Olympia Chimney components when they’re available at honest lead time and price. When an aftermarket equivalent from DuraFlex, HeatShield, or Gelco meets or exceeds the specification - same alloy grade, same insulation rating, same UL listing - we present both options with the price difference. You choose. We don’t substitute without disclosure.
The camera decides. A single crack or loose joint often repairs cleanly. Multiple cracks, thinning walls below manufacturer minimum, or deformation from a chimney fire typically mean replacement. We show you the footage, measure the wall thickness where accessible, and explain which category you’re in. If it can wait a season, we’ll say so - and put that in writing too. Call (424) 414-6048 for the inspection.
Most single-flue liner replacements in Sherman Oaks are completed in one day, assuming standard access and no hidden masonry damage. Full rebuilds above the roofline typically run 2-4 days depending on weather and permit timing. We don’t promise same-day dispatch - we book properly, arrive on schedule, and finish what we start.
A failed or missing liner exposes the chimney structure to heat and combustion byproducts. In wood-framed Sherman Oaks homes, that means creosote accumulation in wall cavities and elevated fire risk. With gas appliances, it means potential carbon monoxide leakage through masonry cracks. The hazard is real, but so is unnecessary spending - we’ll show you exactly what the camera sees and whether the condition is urgent or monitorable. Call (424) 414-6048 for the inspection and written assessment.
Written by Corrine Halstead, Owner, Emberly Chimney Cleaners Sherman Oaks at Emberly Chimney Cleaners Sherman Oaks, serving Sherman Oaks and nearby areas.